Annual Inspection / verification - Offshore

SMC can provide Project Engineers for installed SMC System & IMU verification onboard vessel/rig (*).

Verification is performed with newly calibrated reference sensors for the following parameters (where applicable, system dependent) Wind Speed, Wind Direction, Pressure, Temperature, Humidity, Motion data (Motion Sensor).
If the system is equipped with Visibility, Ceilometer, Wave Radar, Water Current/Temperature the verification is conducted as per the manufacturer’s recommendations.
The SMC Engineer will also observe the installation location of each instrument, cabling and overall general condition.

Onsite a SAT report is completed by the engineer and then signed by engineer & the vessel representative.

Following the site visit all the system findings and data are collated and recorded in a Close out Report and sent to client.

* Verification is not a calibration. For a calibration the IMU needs to be returned to SMC or other environmental instrument need to be returned to the manufacturer.

Commissioning/ Installation support - Offshore or Remote

SMC can provide Project Engineers for commissioning and/ or installation support of SMC System & IMU. The commissioning is to verify and confirm that the SMC system is in accordance with the system specifications and displays the data from the connected instruments and is working correct.

The instruments output data format is verified to ensure the correct communication and required information is transmitted to the SMC system, so that it can display the correct visual and numerical data. All of the general Functions including alarms, logging and reports are checked within the SMC system.

The SMC Factory Acceptance test is not to confirm the accuracy of each instrument. Each instrument supplied with the system has been tested and calibrated by the respective manufacturer; and all relevant documentation is supplied with each instrument.